Using a Jigsaw for DIY Chair Rail

Jun 17th

DIY chair rail, chair rail molding is a section that is installed on the wall, usually 30 inches from the floor. When entering a corner molding usually is square at 45 degrees with a saw. However, most of the corners are not perfectly square, and after squaring and installing molding in a corner, there is often a gap in the front. Cut the molding with a jigsaw, you can get perfect joints every time, no matter what your angle is wrong.

DIY chair rail pretty picture
DIY chair rail pretty picture

Talking about diy chair rail, install a molding on the wall on the right side of the edge. Do not cut the ends; just head to head in a corner and nail it to the wall with a hammer, as if squared. Moving the circular saw blade all the way to the left and lock it at 45 degrees. Fit the insert molding left in the mountains. Start the saw and cut the end of the molding to create a reverse cut of 45 degrees. Staring at the molding on its rim on a counter-top. Hold the strip with the left hand. Using the hacksaw, cut along the edge of the molding in which the oblique cut is perpendicular along the front of the molding. Carefully follow the outline with the knife to cut along the inside curve of the molding. It will become very clear when you get to this point.

12 Photos Gallery of: Using a Jigsaw for DIY Chair Rail

Image of: DIY chair rail pretty picture
Image of: DIY chair rail beautiful picture
Image of: DIY chair rail sweet picture
Image of: DIY chair rail cute picture
Image of: DIY chair rail nice picture
Image of: DIY chair rail cool picture
Image of: DIY chair rail beautiful image
Image of: DIY chair rail pretty image
Image of: DIY chair rail sweet image
Image of: DIY chair rail cute image
Image of: DIY chair rail nice image
Image of: DIY chair rail cool image
 

Attach the molding to the wall in place, and pull it through the corresponding piece that is already in place. Portions which were cut with the saw should be just above the profile of the part that is already in place. Check for any gaps. If you see one, set the cut back on the table and cut any protuberances. Check again and cut until it fits snugly against the other piece. Finally, that’s all about diy chair rail that can I share for this time. Thank you.

You Might Also Like Another Post Under: Chair Rail